All information about our services
Metal profiles, rods, strips (to 440 mm. height) band saws; Workpiece cutting 90 degrees or at an angle to 60 degrees in both directions (according to the dimensions provided); Sheet metal (from 6 mm iki 80 mm thickness) gas cutting; Sheet metal cutting guillotine from 1 to 5 mm thickness.
We offer rolling services:
Sheet rolling, hollow sections, pipe rolling / bending. Contact us for more detailed technical information.
Energy – Construction – Oil and gas – and petrochemical sectors
Sheet rolling from 1000mm to 4500mm width. Thickness from 1mm to 100mm. Tubes from 21,3 nm. Also “3D” folding. Square hollow sections 20 x 20 to 400 x 400, rectangles from 50 x 30 to 500 x 300.
Sheet metal rolling services are tested by SCCS according to ISO 9001:2015 standard and this ensures customer confidence, knowing, that maximum attention is paid when rolling the sheets.
Angles, beam rolling. We can offer an edge processing service with modern machines, and other. services enabling the completion of the entire product required by the customer as quickly and qualitatively as possible.
Black steel S275, 430B, P265GH, S355
Hardened steel
Copper
Duplex and Super Duplex steels 2205, S31803
High chromium-molybdenum materials
Stainless steels 304L, 316L, 321
Spec. steels
All materials are certifiedby metallurgical plantscertificates of quality. At the customer’s request, we provide machined steel sheet impact, deformations, aging, thickness test certificates.
Complete match En1090-1. Conformity assessment requirements for structural components, corresponding to the curved components 4 execution class (Exc4). All induction products are CE marked, so that they can be traced.
All production is rated SCCS, which allows to secure customers, that all materials used in manufacture are fit for purpose, has a traceable audit trail and, that the product produced will fully meet its intended purpose.
The CE mark also ensures the competence of the production team, knowledge and skills, as well as maintenance and calibration of production equipment.
The main reason, which makes galvanizing products worthwhile is an economic advantage. Compared to painting, the starting price is higher, but evaluating, that the painting needs to be renewed, the total cost of painting will be higher, than galvanizing. 85 micron zinc layer approximately only after 25 years lose their positive qualities.